Injector inputs and outputs.

[KENS80V]

I got in on a group buy recently and was looking over the "Traction Control Manual V3.2". The connector wiring pinout list on page 28 states that I/P 3 and O/P 3 as being yellow and yellow/black. On page 9 and 27, in the chart it lists these colours as being what appears to be channel I/P 5 and O/P 5. All the other colours seem to match other than 3 and 5.

What is correct for channel 3 and 5 accordingly? Which page should I go by when interfacing to my 8 cylinder LS engines injector wiring?

Do the channel assignments refer to the injector engine cylinder assignments?

[Jonnie]

I got in on a group buy recently and was looking over the "Traction Control Manual V3.2". The connector wiring pinout list on page 28 states that I/P 3 and O/P 3 as being yellow and yellow/black. On page 9 and 27, in the chart it lists these colours as being what appears to be channel I/P 5 and O/P 5. All the other colours seem to match other than 3 and 5.

What is correct for channel 3 and 5 accordingly? Which page should I go by when interfacing to my 8 cylinder LS engines injector wiring?

Do the channel assignments refer to the injector engine cylinder assignments?

Hi there,

It shouldn’t matter which inputs you use as long as each injector signal is connected to the traction ECU. The Racelogic Traction Control system will replicate each signal received from the vehicle’s ECU to fire the injectors and then ‘cut’ them when the system detects wheel slip.

Regards,
Jonnie.