Turbo Dynamics
13-03-2011, 04:01 PM
I purchased the Video Vbox Lite with a Micro Input Module and connected the "CAN" cable supplied.
I have created a nice scene that displays Boost Pressure, Air Fuel Ratio, rpm speed etc...
I have followed instructions on the PDF for setting up the Micro Input Module in Video Vbox Setup. I have checked "lite" and then configured the Micro Input. Digital for RPM and two analogs for my boost pressure and Airfuel.
I have used the calculator to configure offsets etc...
Then configured the gauges to read of the right input.
My Micro input is configured properly. I have a body ground RPM signal wire in the right spot and two analog wires.
The Micro Input detects RPM etc, but nothing is reaching the video vbox.
I suspect the issue is that I have a Micro Input Module designed for the performance box with RS-232 Communication while I need a CAN version.
Is that correct ? or is there something else I need to do to get this done ?
I have tried using the other method and enable VCI and use the "load" option for CAN but I couldn't find the database file that is refered to in the manual:
MICIN01 CAN .dbc
where can I find this file I have searched the Net and your website...can't find it. Nothing is equivalent it seems in the database I have got with your software.
p.s. I find it very difficult to prepare the Micro Input module and configure gauges, I wish there was more gauges available right from the software and an RPM gauge that reads up to 10 000RPM etc...
I have created a nice scene that displays Boost Pressure, Air Fuel Ratio, rpm speed etc...
I have followed instructions on the PDF for setting up the Micro Input Module in Video Vbox Setup. I have checked "lite" and then configured the Micro Input. Digital for RPM and two analogs for my boost pressure and Airfuel.
I have used the calculator to configure offsets etc...
Then configured the gauges to read of the right input.
My Micro input is configured properly. I have a body ground RPM signal wire in the right spot and two analog wires.
The Micro Input detects RPM etc, but nothing is reaching the video vbox.
I suspect the issue is that I have a Micro Input Module designed for the performance box with RS-232 Communication while I need a CAN version.
Is that correct ? or is there something else I need to do to get this done ?
I have tried using the other method and enable VCI and use the "load" option for CAN but I couldn't find the database file that is refered to in the manual:
MICIN01 CAN .dbc
where can I find this file I have searched the Net and your website...can't find it. Nothing is equivalent it seems in the database I have got with your software.
p.s. I find it very difficult to prepare the Micro Input module and configure gauges, I wish there was more gauges available right from the software and an RPM gauge that reads up to 10 000RPM etc...