CAN Configuration

[Sider]

I can't untick the "send acknowledge" box in the CAN config section of the VVBox set up. When I open the menu it is already ticked, each time I click on it I get the standard message about placing unwanted data on the CAN bus, but the tick stays.

The only way I can get rid of it is to change from VCI to Racelogic Mode in the adjacent drop down menu.

I have the four camera box if it makes any difference, and I have sucessfully loged CAN signals in the past. I've updated to the latest (V3) soft/firmware.

Any ideas at all please?

[Lucie]

Hi Sider,

I have tested the issue that you noticed and managed to replicate it here. The fault seems to be triggered when you have an element assigned to a channel which requires the send acknowledge box to be ticked, save the scene, reload it and then try to de-select the box.

I will enter this as a bug and the software team will look into getting it fixed.

Thanks for pointing this out :thumbsup: Sorry for any inconvenience caused:(

If you export the scene and email it to us we will have a look and sort out the settings so you can use it properly....:o

support@racelogic.co.uk

[Lucie]

... After a little more testing I have found that the box cannot be de-selected when 'Log All' under MIM or MICIN is enabled. If these settings are disabled you should be able to turn the send acknowledge off...:rolleyes:

What CAN channels are you trying to log?

[Sider]

... After a little more testing I have found that the box cannot be de-selected when 'Log All' under MIM or MICIN is enabled. If these settings are disabled you should be able to turn the send acknowledge off...:rolleyes:

What CAN channels are you trying to log?

Hi Lucie
I usually use the throttle and steering chanels from the Evo X. I have a connection straight to the ECU (CAN high/low) and plug that directly into the VVBox and load the info from your CAN database.

This only came to light about a month or so ago when I swapped my box for the 4 camera version (previously the original 2 camera version) However it was a rush for the last trackday so I just used the default scene and no CAN. But I think I upgraded the VVBox set up software at the same time.

[Lucie]

Hi Sider,

Have you sorted the setting out now? If not please send the scene over :thumbsup:

[Sider]

Morning Lucie
I have sent you a scene over but I still don't seem able to turn the CAN acknowledge off regardless of if I do anything with MIM etc, or not :confused:

[Lucie]

Ah yes, I just noticed the scene.:o

I was able to deselect the box straight away and have sent it back to you.

I will carry out some further testing on this as it seems to be an intermittant problem...:rolleyes:

Hope the scene is now OK...:thumbsup: