See below for some upgrade info...
Which update files do you need to use?
* If you are running Version 2 firmware – you need to use the ‘watershed’ upgrade.
This will update your unit to Version 3 and install firmware V3.0.30.
* If you are running Version 3 firmware – you need to use the ‘firmware only’ upgrade.
Don’t know what version of firmware you are running? Check Help>About in Video VBOX Setup Software, or open a recent VBO file in notepad and look under the 'comments' section.
* Customers who use NTSC cameras may find that after running the ‘watershed’ upgrade file, their VVB will not accept NTSC scene files. We recommend that all customers who use NTSC cameras should run the NTSC update after running the watershed update to avoid problems.
Note - once the ‘watershed’ file has been used, you will never need to use it again. The Video VBOX will reject the upgrade if you try to run it more than once. For future upgrades, use the ‘firmware only’ files.
How do you run the update?
All VVB updates work in the same way. When you have downloaded the update file, place this on the root directory of an SD card and load the card into the VVB when fully powered. The unit will then upgrade - it will beep when the upgrade is finished. After every upgrade is carried out you must power cycle the box to complete the process. If you are running two updates please remember to power cycle the box in-between upgrades. Failure to do so may result in incorrect operation of the VVB.